Windows NT Drivers for Voodoo2 Glide Driver Version: 2.50 Voodoo2 Control Panel Applet: 4.10.01.0061 Platform: Windows NT Copyright ( 1997-98 3Dfx Interactive, Inc. ) All Rights Reserved 3Dfx Interactive, Inc. Website: http://www.3dfx.com News Server: news.3dfx.com (via http://news.3dfx.com) ======================================================================= What's in the distribution? ======================================================================= This distribution contains the Windows NT drivers for Voodoo2 Based 3D graphics accelerators. NOTE: End-users are recommended to use drivers provided by their board manufacturer to ensure that they can obtain full support. Included Glide Driver Files --------------------------- Voodoo2 - Windows NT: GLIDE2X.DLL - Windows NT Glide Driver for Voodoo2 FXGPIO.SYS - Windows NT Device Driver for Voodoo2 FXPTL.SYS - Windows NT Device Driver for Voodoo2 NTREMAP.SYS - Windows NT Device Driver for Voodoo2 Included Control Panel Files ---------------------------- 3DFXV2PS.DLL - Voodoo2 Windows NT Control Panel 3DFXV2PS.HLP - Voodoo2 Windows NT Control Panel Help VOODOO2.BMP - Voodoo2 Desktop Wallpaper General Files ------------- README.TXT - This File ======================================================================= Installation ======================================================================= Requirements ------------ - Windows NT 4.0 or later - PC with a Pentium II, Pentium Pro, Pentium or similar processor - One free PCI slot (or two free PCI slots for SLI) Installation ------------ The setup program must be run under Windows NT to install the Windows NT drivers and 3Dfx device services. The account used during install must have administrator privileges. 1) Run the self-extracting executable to begin setup. 2) Follow the on screen prompts. 3) After installation you may need to reboot the system. Troubleshooting --------------- #### Q: I have an S3 968/868 video card, why does my system lock up when I run a Glide or Direct3D title. A: S3 968 and 868 chipsets may misreport the mapped memory used. There is a chance that your Voodoo2 card will be assigned by Plug and Play a memory range that is used by the S3 card, but not reported. The Voodoo2 card can be relocated by: Windows NT Users: An NT service called NTREMAP is installed when Glide is added to an NT system. NTREMAP can change the memory address of a Voodoo2 board and prevent a conflict with an S3 card. To use NTREMAP, add the following registry values to: \HKLM\Software\3Dfx Interactive\NTRemap Value Name Type Value ---------- ---- ----- EnableNTRemap DWORD 1 (HEX) ForceAddress DWORD 12000000 (HEX) The Force Address setting will vary, in this example 0x12000000 is used. This is normally free on most systems. NOTE: If you use an address that over-writes another device, Windows NT may not boot. If such a problem occurs, power off the system and remove your Voodoo2. Alter the registry to use a different memory range (or remove the ForceAddress setting). Then Reinstall the Voodoo2 card into your system. Troubleshooting --------------- Please see the Voodoo2 Release Notes and OEM Software Support Guide for additional information.